#1 : 09/11-17 23:32 Mo Olson
Posts: 1
|
What does one need to do to return to the Folder that one is making changes to after going through the procedure of "Open" -- "Start Batch" -- "Start" (renaming)
After I go through the above steps, I have to click on Documents, File Folder, sub folder to continue making changes to the sub folder I am working with It seems that in the past the program returned to the folder I was working with --- but have somehow gotten out of sequence and don't know what I am doing different now such that it does not return to the folder I'm working on. |
#2 : 02/02-18 06:38 Brian Hanlon
Posts: 29
|
Reply to #1:
1. Turn Auto-Test OFF 2. Set up your initial Rule(s) 3. Press 'Test Batch' 4. Observe proposed results in (scrollable) middle window 5. If satisfied, 'Run Batch" else Add/Change Rules as required and return to 3. That should do it without reloading your selection. (Also, after a batch has 'Run', there is a text 'Link' on the lower right hand side, which allows you to 'Add all successful items' which would reload your list for you.) Hope that makes life easier, Brian. |